RIGOL    Contents 
 
DS1000B Service Guide 
Figures 
 
Figure 2-1 To Connect the power cord .............................................................. 2-3 
Figure 2-2 Power-on Inspection ....................................................................... 2-3 
Figure 2-3 BNC Interface Connection ................................................................ 2-4 
Figure 2-4 Circuit Under Test Connection .......................................................... 2-4 
Figure 2-5 To Set the Probe Switch and Attenuation Coefficient .......................... 2-5 
Figure 2-6 To Connect the Probe Compensator .................................................. 2-5 
Figure 2-7 Waveform Compensation ................................................................. 2-6 
Figure 3-1 Connection of the USB Host Interface at the Front Panel .................... 3-2 
Figure 3-2 Connection of the USB Host Interface at the Rear Panel ..................... 3-2 
Figure 3-3 USB Storage Device Connection Succeeds ......................................... 3-3 
Figure 3-4 USB Device Interface Connection ..................................................... 3-4 
Figure 3-5 USB Device Interface Connection Fails .............................................. 3-4 
Figure 3-6 LAN Setup Interface ........................................................................ 3-5 
Figure 3-7 Remote Control Interface Based on LAN Interface Connection ............. 3-5 
Figure 3-8 To Connect the Test Devices ............................................................ 3-6 
Figure 4-1 Self-calibration interface .................................................................. 4-1 
Figure 4-2 Self-Calibration Finishes................................................................... 4-2 
Figure 5-1 DS1000B Stereogram ...................................................................... 5-3 
Figure 5-2 To Disassemble and Assemble the Cover ........................................... 5-4 
Figure 5-3 To Disassemble and Assemble the Upper Metal Cover......................... 5-5 
Figure 5-4 To Disassemble and Assemble the Rear Metal Cover and Power Board . 5-6 
Figure 5-5 To Disassemble and Assemble the Interface Board and Fan ................ 5-8 
Figure 5-6 To Disassemble and Assemble the Panel and LCD .............................. 5-9 
Figure 5-7 To Disassemble and Assemble the Keyboard .................................... 5-10 
Figure 5-8 To Disassemble and Assemble the Main Board ................................. 5-11 
Figure 7-1 DS1000B Exploded View .................................................................. 7-1