Do you have a question about the Rigol DS1104Z and is the answer not in the manual?
Bandwidth | 100 MHz |
---|---|
Channels | 4 |
Sample Rate | 1 GSa/s |
Waveform Capture Rate | 30, 000 wfms/s |
Vertical Sensitivity | 1 mV/div to 10 V/div |
Time Base Range | 5 ns/div to 50 s/div |
Vertical Resolution | 8 bits |
Interface | USB Host, USB Device, LAN, AUX |
Display | 7 inch TFT LCD (800 x 480) |
Trigger Types | Edge, Pulse, Video, Slope |
Power Supply | 100-240 V, 45-440 Hz |
Memory Depth | 24 Mpts (Single Channel), 12 Mpts (Dual Channel) |
Overview of essential safety precautions before operating the oscilloscope.
Initial checks for shipping damage, instrument condition, and accessories.
Instructions on tilting the oscilloscope using its supporting legs.
Steps to safely connect the instrument to mains power.
Instructions for using the instrument's carrying handle.
Connecting the oscilloscope to a network for remote control.
Connecting printers or PCs via the instrument's USB port.
Description of trigger output and pass/fail signal functions.
Using the built-in dual-channel signal source output terminals.
Information and procedure for replacing the instrument's fuse.
The primary connection point for AC power input.
Controls for vertical positioning and scaling of waveforms.
Accessing and utilizing mathematical functions on signals.
Enabling reference waveform display for signal comparison.
Functions and controls for analyzing digital signals.
Configuration settings for the instrument's built-in signal generators.
Solutions for a blank or unresponsive screen after powering on.
Troubleshooting steps when no signal waveform is shown on screen.
Addressing issues with incorrect voltage readings or amplitude measurements.
Tips for resolving jittery, unstable, or drifting waveforms.
Diagnosing issues when waveform acquisition stops or fails to display.
Resolving step-like artifacts or staircase patterns in waveform display.
Steps to troubleshoot connectivity problems with USB devices.
Solutions for the oscilloscope failing to detect USB storage devices.