Rigol DS1302CA - Chapter 2 Command Systems

Programming Introduction RIGOL
Programming Guide for DS1000CA Series
2-1
Chapter 2 Command Systems
This chapter gives detailed information on each command supported by DS1000CA
series oscilloscopes, including command format, function explanation, using
methods and considerations.
DS1000CA series include the following commands:
 General Commands
 SYSTem Commands
 ACQuire Commands
 DISPlay Commands
 TIMebase Commonds
 TRIGger Commands
Trigger Control
EDGE Trigger
PULSe Trigger
VIDEO Trigger
SLOPe Trigger
ALTernation Trigger
 STORage Commands
 MATH Commands
 CHANnel Commands
 MEASure Commands
 WAVeform Commands
 KEY Commands
 CURSor Commands
 Other Commands