Rigol DS1302CA - Measure Commands

RIGOL Programming Introduction
Programming Guide for DS1000CA Series
2-54
MEASure Commands
MEASure Commands are the fundamental measurement operations and the
measurement results are usually expressed in scientific numeric notation.
MEASure Commands include:
 :MEASure:CLEar
 :MEASure:VPP?
 :MEASure:VMAX?
 :MEASure:VMIN?
 :MEASure:VAMPlitude?
 :MEASure:VTOP?
 :MEASure:VBASe?
 :MEASure:VAVerage?
 :MEASure:VRMS?
 :MEASure:OVERshoot?
 :MEASure:PREShoot?
 :MEASure:FREQuency?
 :MEASure:RISetime?
 :MEASure:FALLtime?
 :MEASure:PERiod?
 :MEASure:PWIDth?
 :MEASure:NWIDth?
 :MEASure:PDUTycycle?
 :MEASure:NDUTycycle?
 :MEASure: PDELay?
 :MEASure:NDELay?
 :MEASure:TOTal
 :MEASure:SOURce
The detailed information of each command are given as follows: