Rigol DS1302CA - Page 91

Programming Introduction RIGOL
Programming Guide for DS1000CA Series
2-79
1. :CURSor:MODE
Command Format:
:CURSor:MODE {CLOSe|MANUal|TRACk|MEASure}
:CURSor:MODE?
Function Explanation:
This command is used to set and query system cursor mode as “CLOSe”,
“MANUal”, “TRACk” or “MEASure”.
Returned Format:
Query returns CLOSe, MANUal, TRACk or MEASure.
Example:
:CURS:MODE TRAC Set cursor mode as “TRACk”
:CURS:MODE? Query returns TRACk
2. :CURSor:MANUal:TYPE
Command Format:
:CURSor:MANUal:TYPE {TIME|AMPlitude}
:CURSor:MANUal:TYPE?
Function Explanation:
The commands are used to set and query cursor type as “TIME” or
“AMPlitude” in manual mode.
Returned Format:
Query returns TIME or AMPlitude.
Example:
:CURS:MANU:TYPE TIME Set cursor type as “TIME”
:CURS:MANU:TYPE? Query returns TIME
3. :CURSor:MANUal:SOURce
Command Format: