Need help?Do you have a question about the Rigol RPL1116 and is the answer not in the manual?
General| Brand | Rigol |
|---|---|
| Model | RPL1116 |
| Category | Accessories |
| Language | English |
Connect the active logic probe head to the main cable input, and then connect the main cable output to the digital signal input terminal on the front panel of the oscilloscope.
Users can connect any number (≤16) of signals to RPL1116. Ensure input signal amplitude does not exceed the probe's working voltage range.
Access the probe setting menu via the oscilloscope's LA button to configure parameters like threshold level, waveform size, and probe calibration.
Verify signal display on the oscilloscope after connection and setup. Troubleshoot by adjusting settings or checking connections if no signal appears.
To Next Page