Model 2424WCwww.rinnaiamerica.com 34
INSTALLER’S INSTALLATION INSTRUCTIONS
Remote Controls- General
The remote control for the Continuum 2424WC allows the customer to control the
functions of the water heater and to diagnose certain fault conditions.
The Main Controller model MCC-45-3US is intended to be installed in the kitchen
or laundry area where the majority of the hot water is being used.
NOTE: The MC-45-3US has a temperature setpoint range of 140-180°F. Other
setpoint temperatures must be set through dip switch settings, Contact
Rinnai at 800-621-9419 for dip switch settings.
Before installing the remote control, determine the most convenient location. When
deciding on the best location for the remote controls, please consider the following
items:
1) Place the controllers out of the reach of small children or unauthorised users.
2) Avoid locations where the controller will become hot. (over a stove, near an
oven or a radiant heater.
3) Avoid direct sunlight. (The digital monitor can be difficult to read in direct
sunlight)
4) Avoid areas where the remote can be splashed with cooking water, oil or
sauce.
5) The remote control cables carry low voltage, 12VDC digital.
NOTE: Only one controller can be connected to one Continuum 2424WC water
heater. (i.e. Installations with two controllers will not function properly.)
To Next Page
Loading...
Need help?
General
