To Next PageTo Next Page
Need help?Do you have a question about the Rinnai Energysavers RHFE-309FT and is the answer not in the manual?
General| Model Number | RHFE-309FT |
|---|---|
| Category | Heater |
| Fuel Type | Natural Gas/Propane |
| Efficiency | 80% AFUE |
| Electrical Requirements | 120V, 60Hz |
| Gas Connection Size | 1/2 inch |
| Control Type | Electronic |
| Ignition System | Direct Spark Ignition |
| Venting | Direct Vent |
| Input Rating (NG/LP) | 30, 000 BTU/h |
| Heating Capacity | Up to 1, 000 sq ft |
| Thermostat | Built-in Thermostat |
Outlines the terms and conditions of the Rinnai limited warranty for the product.
Essential safety precautions and warnings for operating and maintaining the Energysaver heater.
Emphasizes the need for a licensed installer for safe and proper setup.
Step-by-step guide on how to turn the Energysaver heater on and off.
Step-by-step instructions for setting the appliance's clock time.
Guide to programming Timer 1 and Timer 2 for automatic heating periods.
How to clean the fan filter to maintain efficiency and prevent shutdowns.
Lists common error codes, their probable causes, and suggested solutions.
Checks for timer issues, including incorrect settings or room temperature.
A checklist of probable causes for faults and their possible solutions.
Pre-installation checks, unpacking, and component verification for installers.
Details on connecting the gas supply, pipe sizing, and purging.
Instructions for connecting the heater to a dedicated earthed power point.
Mandates the use of a Rinnai flue system and its assembly.
Steps for connecting the appliance to the gas supply pipe.
Steps for installing the flue system and connecting it to the appliance.
Steps for commissioning the appliance and customer handover.
