To Next PageTo Next PageWhat to do if there is power interruption during bath fill with my Rinnai Water Heater?
If you experience a power interruption during a bath fill and the water will not flow when the power is restored, turn off all hot water taps. Then, press the On/Off button twice.
What to do if my Rinnai Water Heater has no ignition or gas supply?
If your Rinnai Water Heater has no ignition or gas supply, check that the gas is turned on at both the water heater and the gas meter or cylinder.
What to do if my Rinnai Water Heater starts then the water goes cold?
If your Rinnai Water Heater starts but the water goes cold, verify that the power is still on. Additionally, try opening your hot water tap further.
How to fix no ignition / no gas supply on Rinnai INFINITY 16 Water Heater?
If your Rinnai Water Heater isn't igniting or has no gas supply, verify that the gas is turned on at the water heater, gas meter, or cylinder.
What to do if power interruption during Bath fill in Rinnai INFINITY 16 Water Heater?
If a power interruption occurs during a bath fill and water doesn't flow when power is restored to your Rinnai Water Heater, turn off all hot water taps and press the On/Off button twice.
Why does my Rinnai INFINITY 16 start and then the water goes cold?
If your Rinnai Water Heater starts and then the water goes cold, verify that the power is still on. Also, try opening your hot water tap further.
How to fix a noticeable reduction in water flow in Rinnai INFINITY 16 Water Heater?
A noticeable reduction in water flow in your Rinnai Water Heater might be because the inlet water filter needs cleaning. A service call is recommended.
How to fix a noticeable reduction in water flow in my Rinnai Water Heater?
If you notice a reduction in water flow in your Rinnai Water Heater, the inlet water filter may need to be cleaned. It is recommended to schedule a service call.
What to do if my Rinnai INFINITY 16 Water Heater does not attempt to start at all?
If your Rinnai Water Heater does not attempt to start at all, check that the power is on at the unit. Also, ensure that the isolation valves at the unit are open.
What to do if Rinnai INFINITY 16 has flame failure / low gas flow?
If you're experiencing flame failure or low gas flow with your Rinnai Water Heater, start by checking that the gas is turned on at both the water heater and the gas meter or cylinder. Also, ensure there are no obstructions blocking the flue outlet.
General| Weight | 42 lbs |
|---|---|
| Energy Factor | 0.82 |
| Minimum Flow Rate | 0.5 GPM |
| Temperature Control | Digital |
| Maximum Water Pressure | 150 PSI |
| Ignition | Electronic |
| Type | Tankless |
| Flow Rate | 16 L/min |
| Installation | Indoor |
| Gas Type | Natural Gas |
| Temperature Range | 37°C to 60°C |
| Dimensions | 571 mm x 355 mm x 194 mm |
| Maximum Flow Rate | 16 L/min |
| Gas Connection | 1/2" NPT |
| Water Connection | 3/4" NPT |
| Electrical Requirements | 120V |
| Dimensions (H x W x D) | 571 mm x 355 mm x 194 mm |
| Minimum Input | 15, 000 BTU/hr |
