To Next PageTo Next Page
Need help?Do you have a question about the Rinnai INFINITY 18 REU-V2018W and is the answer not in the manual?
General| Model | INFINITY 18 REU-V2018W |
|---|---|
| Category | Gas Heater |
| Type | Continuous Flow |
| Maximum Flow Rate | 18 L/min |
| Ignition System | Electronic Ignition |
| Energy Star Certified | Yes |
| Gas Type | Natural Gas |
| Temperature Range | 60°C |
| Warranty | 3 years |
General warning about complying with instructions for safety.
Warning regarding high voltage wiring within the appliance.
Instruction that all service work must be done by authorized personnel.
Warning against testing for gas leaks with an open flame.
Details the step-by-step operational sequence for normal conditions.
Flow chart illustrating ignition sequence and failure modes.
Flow chart for air supply or exhaust blockage issues.
Explains the role of the PCB in controlling all operational functions.
Describes how gas flow is regulated for temperature control.
Explains how water flow is detected and controlled.
Step-by-step guide for connecting remote control cables.
Steps for connecting three remote controllers to the appliance.
Instructions to program the kitchen controller for temperature settings.
Diagram illustrating the appliance's electrical wiring.
A flowchart guiding the process of diagnosing faults.
Covers faults related to ignition, flame, and combustion fan.
Addresses faults related to thermistors and overheat switches.
Details faults concerning control circuits and solenoid valves.
Covers appliance non-operation, wiring, and temperature adjustment faults.
Procedures to check the combustion fan, its sensor, and the sparker.
Procedures to check the main solenoid valve circuit.
Procedures to check solenoid valve 2 and the modulating valve circuits.
Procedures to check the flame rod, earth lead, and thermal fuse circuits.
Procedures to check overheat switch and water flow sensor circuits.
Procedures to check outlet thermistor and surge protector circuits.
Procedures to check remote control and anti-frost heater circuits.
Procedures to check the water flow servo circuit.
How to access maintenance and error history via wireless controller.
Step-by-step guide to view maintenance data on the controller.
Instructions on how to view the last 10 recorded faults.
Explains how error codes and sequence are shown on the display.
Adjusting regulator and setting dip switches for combustion.
Checking test point pressure and adjusting the POT.
Setting for normal combustion, final checks, and warnings.
General steps for converting the appliance to a different gas type.
Detailed steps for manifold replacement and component reconnection.
Final checks, connection to services, and pressure settings.
Essential safety precautions before dismantling the appliance.
Steps for removing the front panel and PCB unit.
