11
008082013GW
NOTE; in order to reset all parameters in your boiler back to factory defaults follow the “Activating Factory Settings”
(Green button function) instructions found in your owner’s manual. CUATION: All parameters you adjusted will now
have to be reprogrammed if the bL60 code clears up. If after resetting the boiler the bL60 still appears, you will need to
replace the sub-PC board and reprogram the MCBA. The sub PC board must be from a conversation kit for the same gas
type as your boiler.
If conversion parts are not locally accessible contact Rinnai Tech Support for assistance. These parameters cannot be
accessed in the field and may require special instructions in an emergency situation.
To Next Page
Loading...
Need help?
General
