21
008082013GW
Due to insufficient
ionization the burner
has shut down after
ionization cable or
02 setting
Ignition Failure Issue
Note: if ionization is lost while the flame is
burning no E02 will occur - unit will attempt to
relight 6 times. E02 only occurs after 6 failed
attempts for re-ignition.
Propane gas with low BTU value or a brand
new tank that may contain something other
than pure propane may cause E02. Check
against a good known source of gas.
The minimum ionization current
should be 4 micro amps (Check
INFO step 48, the O2 should be a
minimum of 4.4% for NG or 4.8%
for LP.
To Next Page
Loading...
Need help?
General
