19
008082013GW
burning but an
ionization flow
(flame) has been
detected.
NOTE: Inadvertently unplugging the ionization
cable or spark igniter wire while the boiler is
not firing can trigger the E00 code.
Check whether the ionization cable and/or the electrode
are responsible for a short circuit. Remove the plugs from
the ionization cable connected to the control unit and to
the electrode. Now using a ohm meter take a
measurement between the ionization connection and the
ground. Now refit it part by part until a short circuit takes
place.
To Next Page
Loading...
Need help?
General
