To Next PageTo Next Page
Need help?Do you have a question about the Rinnai RHFE-952ER and is the answer not in the manual?
General| Category | Heater |
|---|---|
| Model | RHFE-952ER |
| Fuel Type | Natural Gas |
| Maximum Input | 199, 000 BTU/hr |
| Minimum Input | 15, 000 BTU/hr |
| Flow Rate | Up to 9.5 GPM |
| Ignition Type | Electronic |
Requirements for installing the heater, including compliance with local regulations and manufacturer's instructions.
Details the heater's certification by the Australian Gas Association.
Refers to a separate manual for flue system installation.
Lists components supplied in separate cartons for the heater.
Section for recording installer and company information for the installation.
Section for recording model, serial number, and installation address of the appliance.
Illustrates and labels the main components and features of the heater's design.
Highlights key operational features like room sealing, push-button ignition, and remote control.
Warning against unauthorized modifications due to risks of fire, explosion, injury, or death.
Covers installation compliance, flue terminal placement, material clearances, and usage by persons with disabilities.
Addresses supervision of children, power supply requirements, and not using damaged heaters.
Lists actions to avoid during operation, such as blocking vents or using aerosols near the heater.
Details requirements for power points, avoiding power boards, and heater placement relative to outlets.
Explains the function of various safety mechanisms like thermistors, fuses, and flame failure systems.
Step-by-step guide for starting the heater using the control panel.
Instructions for switching the heater off using the control panel.
Explains the safety feature for unattended starts and restart procedures.
Describes operation via remote control versus limited use of the panel button.
Crucial safety warning regarding appliance ON/OFF button and STANDBY mode.
Guide on battery installation and confirmation of remote control function.
Details the functions of remote control buttons for flame height and fan speed.
Step-by-step instructions for replacing batteries in the remote control.
How to operate the appliance if the remote is lost or broken.
Guidelines for cleaning the heater, including what to avoid.
Information on filter location, cleaning, and shut down due to blockages.
Importance of keeping the warm air discharge vent clear and how obstructions affect operation.
Explains normal operating noises and characteristics that do not indicate a fault.
Recommendations for periodic servicing and warranty coverage for service calls.
Guide to identify potential issues and determine if a service call is needed.
Describes expected flame patterns and what constitutes abnormal behavior.
A table listing fault conditions, probable causes, and possible remedies.
Explains how error codes are displayed and how to resolve them.
Details the appliance's self-diagnostic features and lists error codes with probable causes and remedies.
Details technical specifications for the RHFE-952ER and RHFE-1252ER models.
Provides detailed measurements for the heater models.
Details specific enclosure dimensions and warnings about flue system types.
Specifies dimensions for gas supply and flue pipe penetrations in walls.
Information on connecting the gas supply and purging the system.
Details requirements for the power supply connection and recommended wiring practices.
Specifies clearances required when installing a mantle above the heater.
Overview of different flue installation types and required components.
Details the components and requirements for the flue system transition assembly.
Specifies minimum clearances for flue terminals based on AS/NZS 5601.
Instructions for unpacking the heater and checking for damage or missing parts.
Details on connecting the flue system components to the heater.
Instructions for securely mounting the heater engine using provided mounting points.
Details on connecting the gas supply, including leak testing.
Instructions for removing the glass panel and installing burner media (logs or stones).
Step-by-step guide for installing the ceramic log set specific to the RHFE-952ER model.
Step-by-step guide for installing the ceramic log set specific to the RHFE-1252ER model.
Instructions for placing granular burner media over logs/stones for flame enhancement.
Guide for placing ceramic river stones for aesthetic appeal.
Steps for removing and refitting the combustion chamber glass panel.
Procedures for setting gas pressures and checking appliance operation after installation.
Instructions for attaching the outer fascia panel to the heater engine.
Steps for mounting the inner fascia panel onto the combustion chamber frame.
A checklist for installers to verify installation and commissioning steps.
A checklist for the certified gas installer to confirm all installation requirements are met.
Explains the markings and wire colours used in the wiring diagram.
Illustrates the electrical connections for the heater's components.
