Rinnai Symmetry RDV3611 User Manual (English)

Other manuals for Rinnai Symmetry RDV3611

Operation Guide20 pages

Maintenance Instructions20 pages

Instructions2 pages

Questions and Answers:

J
Jack MartinAug 13, 2025
How to fix a Rinnai Symmetry RDV3611 Indoor Fireplace when the burner will not light?
- J
  Jordan HardinAug 13, 2025
  If the burner of your Rinnai Indoor Fireplace will not light, it could be due to several reasons: * No power: Ensure the power cord is plugged in and turned on. * No gas: Ensure the gas supply is turned on. * Power cut: Re-ignite after power is restored. * Air in gas pipe: Purge air (this should be done by an installer). * Ignition failure: Repeat the ignition steps.
E
Elizabeth ChristensenAug 16, 2025
What to do if the controller display of my Rinnai Symmetry RDV3611 Indoor Fireplace is blank?
- J
  Jordan GutierrezAug 16, 2025
  If the controller display of your Rinnai Indoor Fireplace is blank, it's likely due to flat batteries. Check the batteries and replace them with new ones if necessary.
A
Amanda WallaceAug 20, 2025
What to do if the power LED is on but the Rinnai Symmetry RDV3611 isn’t going and the controller doesn’t work?
- A
  aballAug 20, 2025
  If your Rinnai Indoor Fireplace isn't going, but the power LED is on and the controller isn't working, it indicates a fault mode. To resolve this, press the On/Off button on the control panel once (the LED will flash), then press it again (the LED will stay on). The fire should then attempt to re-ignite, and the controller should start working.
K
Kristi RhodesAug 25, 2025
What to do if I smell gas from my Rinnai Symmetry RDV3611?
- T
  Terry SparksAug 25, 2025
  If you smell gas from your Rinnai Indoor Fireplace, it could be due to a gas leak. Immediately turn off the gas supply at the meter or LPG cylinder and contact your installer.
J
Janet MendezAug 27, 2025
Why does my Rinnai Symmetry RDV3611 keep turning itself off?
- S
  susandiazAug 28, 2025
  Your Rinnai Indoor Fireplace might keep turning itself off because the set room temperature has been reached, which is normal operation. The fire turns off once it reaches the set temperature. To keep the fire on continuously, switch to flame mode or increase the set temperature.
S
Sara CortezAug 31, 2025
Why does my Rinnai Symmetry RDV3611 Indoor Fireplace come on at the wrong time?
- J
  Jennifer StokesAug 31, 2025
  If your Rinnai Indoor Fireplace comes on at the wrong time, it's likely that the program is not set correctly. Check the program periods and ensure the AM/PM settings on the controller are correct.
T
tracymartinSep 4, 2025
Why is there condensation on the glass of my Rinnai Indoor Fireplace?
- M
  melissa02Sep 4, 2025
  If you notice condensation on the glass of your Rinnai Indoor Fireplace, this is normal during operation. Simply allow the heater to warm up, and the condensation will disappear.
K
Kendra RussellSep 7, 2025
Why is there a small soot deposit on the logs of my Rinnai Symmetry RDV3611 Indoor Fireplace?
- M
  Melanie KhanSep 7, 2025
  A small soot deposit on the logs of your Rinnai Indoor Fireplace is a result of normal operation, so no action is required.

Rinnai Symmetry RDV3611 Specifications

General

Type	Direct Vent Gas Fireplace
Fuel Type	Natural Gas or Propane
Ignition System	Electronic Ignition
Venting	Direct Vent
Warranty	Limited Lifetime Warranty
Control Type	Remote Control
BTU Input	36, 000 BTU
Log Set	Ceramic Fiber