33
AUTOMATIC MECHANICAL WATCHES
AB
Crown
GETTING THE WATCH STARTED
Automatic mechanical watches do not require a battery.
There are 2 methods of starting your watch.
1. You can wind the watch turning the crown in a clockwise direction
approximately 15 times. Make sure you don’t over wind it.
2. You can also wind your watch by swinging your arm.
We recommend you 1
st
wind the watch to get it started and then by
wearing the watch you will continue to give power to the watch.
NOTE :
* When you take your watch off the power reserve is approx 24 to 36 hours.
SETTING THE TIME
Pull the crown out to position B.
Turn the hour/minute hands in a clockwise direction to set the time.
WARNING!
For the watch to be properly sealed, the crown must be fully pushed in.
Never pull the crown out when the watch is in water or is wet.
To Next Page
Loading...
