64
STAINLESS STEEL STRAPS
BAND LENGTH ADJUSTMENT:
Major Adjustments to the length of your strap must be made by removing
the correct amount of metal links to fit your wrist. Links should be taken out
as evenly as possible from both sides.
1. Note the direction of the small engraved ar-
rows on the back of strap links.
2. Use a thumb tack firmly push out the first
split-pin in the direction of the arrow. Fig.1
3. Pull out the split pin fully. The strap now comes
apart. Repeat this step for each link to be re-
moved. Fig.2
4. Now align the two ends of the strap and re-
place the pin in the opposite direction of the ar-
row. Be sure to note the correct end of the split
pin to insert. Fig.3
5. Firmly press the pin back into place using a
hard object. Next lightly tap the pin fully into place.
Fig.4
Repeat steps 2 to 5 on other side of band
To Next Page
Loading...
