15
Packaging
All kinds of objects with irregular
shapes can also be packaged using
shrink-wrap film.
To obtain a good film joint, you need
to provide a minimum overlap of
30 cm (diagram M).
Start by heating the film in a
continuous movement and then put
pressure on this part using a spatula
to connect the two parts together.
Once the joint has been made,
continue the shrink-wrapping by
holding the appliance at least 30 cm
from the film. When doing this, be
sure to follow the recommendations
for shrink-wrapping.
NOTE: The combustion nozzle can
rotate freely and this will make your
work easier (diagram P).
Put the nozzle in the required
position.
To Next Page
Loading...
