17
Cleaning:
Frequency:
Non-polluted environment: Every 500 hours.
Polluted environment: As soon as it is noticed that there is a reduction in power.
C
LEANING
THE
NOZZLE
GRILLE
:
•
Place the nozzle for a few minutes in a dry petrol bath (e.g. F petrol) to
make sure the various tightness systems are not damaged. Grease
products (e.g. oil) are not recommended because they attract impurities
afterwards.
NEVER USE AN Y OTHER DEGRE AS IN G PRODUCTS F OR CLE ANIN G.
•
Clean the inside and the outside of the nozzle grille with a paintbrush or
a hard brush.
•
Clean the receiving tube of the spark plug.
•
Rinse it again and apply compressed air
(block the hole on the grille side
intermittently for intensive blowing of the
inside of the receiving tube).
•
Put the spark plug back into position and
check that it is pressed far enough.
Incorrect positioning may cause the electric
contact of the spark plug to deteriorate.
To Next Page
Loading...
