18
C
LEANING
THE
VENTURI
:
The venturi must be cleaned in dry condition.
•
Clean the venturi with a paintbrush or a hard brush.
•
Apply compressed air in the direction of the injector/nozzle to avoid
polluting the injector.
•
Test the operation by performing the procedures in the chapter
"Operation". If the gun has not regained its full power, clean the injector.
C
LEANING
THE
INJECTOR
:
WARNING: Do not dismantle the
injector support (2 screws with
slotted head).
Note: The injector support is aligned in the factory with special tools in order to
obtain maximum efficiency of the flame.
To Next Page
Loading...
