Ripack 2200 - Ignition Difficulty Causes; Insufficient Power Causes

21
PROBLEMS CAUSE REMEDIES
The combustion
nozzle doesn't/is
difficult to ignite.
Bad contact or bad
insulation.
C h e c k t h e
contact at the
spark plug end.
C h e c k t h e
contact in the
sleeve.
Piezoelectric lighter
run down.
Contact your RIPACK dealer.
Electrode burnt or
broken.
Change the spark
p l u g ( s e e
"Cleaning").
Combustion nozzle is
dirty.
Clean the nozzle
g r i l l e ( s e e
"Cleaning").
The gas bottle valve
is open too far.
The pressure control
of the SECURIPACK
is not in its maximum
position.
The gas you are
using is not propane.
Use propane gas.
The bottle capacity is
too low.
Use a bottle with a larger
capacity.
The combustion
nozzle has
insufficient power.