- 14 -
The various films react differently, so you must
observe the reaction and adapt your speed and
movement and/or the distance between the
nozzle and the film accordingly.
You can also adjust the power of the
RIPACK
S
ERIES
3000 with the adjustable
SECURIPACK controls.
Once the lower part of the pallet has been shrink-
wrapped, continue the operation for each side
and move from top to bottom to cover the entire
height.
Once the 4 sides have been shrink-wrapped, you
can do the top by applying the hot air to the top of
the pallet.
Caution: The film is already stretched along the
sides so you should apply less heat on the top in
order to prevent the cover from being damaged.
When you have stopped applying heat with the
gun, the plastic film, because of its make-up, will
continue to shrink for some time. This time will
vary depending on the quality, the thickness and
the type of load that has been wrapped. It is
recommended therefore that you wait until the
cover has cooled off and everything is tight before
moving the pallet.
After cooling and before storage, always check
that the cover and the wrapped goods are in good
condition.
CHECK CAREFULLY FOR AT LEAST 2 HOURS
AFTER SHRINK-WRAPPING.
N.B.: The RIPACK
®
S
ERIES
3000 carrying case also acts
as a foot stool and enables the operator to stand at a height
of 27 cm from the ground to ease work on tall pallets.
To Next Page
Loading...
