- 13 -
EXAMPLES OF USE
Shrink-wrapping a loaded pallet
Ask your film supplier for the operating instructions.
The pallet must be lifted so that the four corners are
accessible: the purpose of this is to allow the film to be
shrunk under the pallet and so ensure very strong
cohesion between the pallet and the load it supports.
You will find an accessory in the RIPACK product
range that is designed specially to keep pallets lifted
from the ground: the CALPACK (contact your dealer).
Slide the shrink cover, which must be about 5% wider
than your pallet and sufficiently long to be able to be
shrunk under the pallet (H plus 200 mm).
Ignite your RIPACK
S
ERIES
3000 as explained in the
chapter "Operation".
SHRINK-WRAPPING RECOMMENDATIONS
(in the absence of instructions provided by the film manufacturer) :
Remain at a distance of at least about 30 centimeters
from the film and start shrink-wrapping the lower part
of the four sides so the pallet is shrink-wrapped
underneath. Make sure you point the air flow
perpendicularly along the sides of the pallet.
Apply the heat in a continuous movement and at a
constant speed.
NEVER STAY ON THE SAME SPOT
To Next Page
Loading...
