- 15 -
Packaging
All kinds of objects with irregular
shapes can also be packaged using
shrink-wrap film.
To obtain a good film joint, you need
to provide a minimum overlap of
30 cm.
Start by heating the film in a continuous
movement and then put pressure on this part
to connect the two parts together.
Once the joint has been made, continue the
shrink-wrapping by holding the appliance at
least 30 cm from the film. When doing this, be
sure to follow the recommendations for shrink-
wrapping.
NOTE: The combustion nozzle can
rotate freely and this will make your
work easier.
Put the nozzle in the required position.
To Next Page
