Risco Pro-24 - Page 33

Installation and Programming Manual 3-7
I
I
n
n
s
s
t
t
a
a
l
l
l
l
e
e
r
r
P
P
r
r
o
o
g
g
r
r
a
a
m
m
m
m
i
i
n
n
g
g
B
B
a
a
s
s
i
i
c
c
s
s
The LCD Keypad offers you the facility to navigate through the menu structure as you see fit–to reach your desired
destination(s). Before beginning, be sure your Pro-24 is connected to an LCD Keypad which has been given the
physical I.D. of “01”, and to a power source (AC and Standby Battery). After applying power to your system, locate
the display produced by your keypad. Then read and follow the applicable comments in the appropriate column.
With power applied, this display
represents an Pro-24 which is
unprogrammed (i.e. has stored only
factory defaults) OR one whose LCD
Keypad is not properly identified to the
system.
To enter Installer Programming from
this type of display, press the [,] key
and proceed to the steps, directly
below.
This display represents that of a previously-programmed Pro-24 in
which the term “PARTITION 1” is the name designated for the
system or for one of its partitions. To enter Installer Programming
from this type of display, press the [,] key and proceed to the
steps, below.
Note: If the time and date have NOT been
previously programmed or if power to the system has been
interrupted, the display will show “blanks” for these fields on the
bottom line.
1- If the panel has never been
programmed, or still uses the default
Installer Code, enter
[ 0 ] [ 2 ] [ 9 ] [ 6 ]
If there is another Installer Code
assigned to this panel, enter it
instead.
2- Once done, press [ENTER].
3- The display will show:
which is the starting point each time
you enter Installer Programming.
1- From the display showing:
press [7] to select:
and press [ENTER].
2- Enter the Installer Code currently in use for this panel, or use the
factory default [ 0 ] [ 2 ] [ 9 ] [ 6 ], if applicable,
and press [ENTER].
3- The display will show:
which is the starting point each time you enter Installer
Programming.
Although these steps may have been performed earlier, it’s always a good idea to check that the LCD
Keypad from which programming is to be performed has been properly identified to the Pro-24. To do so,
perform the procedure in pages 3-2 and 3-3.
To Install
Press .
PARTITION 1
--:-- ... .. ...
INSTALLER CODE:
_
USER FUNCTIONS
1)BYPASS
↓
INSTALLER PROG:
1)ADVANCED
↓
INSTALLER CODE:
_
INSTALLER PROG:
1)SYSTEM ↓
INSTALLER PROG:
1)SYSTEM ↓