Risco Pro-24 - Section 3: Programming Your Pro-24

Installation and Programming Manual 3-1
Section 3: Programming Your Pro-24
S
S
u
u
m
m
m
m
a
a
r
r
y
y
o
o
f
f
I
I
n
n
s
s
t
t
a
a
l
l
l
l
e
e
r
r
P
P
r
r
o
o
g
g
r
r
a
a
m
m
m
m
i
i
n
n
g
g
M
M
e
e
t
t
h
h
o
o
d
d
s
s
As a source of general reference, the following table lists the options available when programming an Pro-24
installation. Except for this reference, this section will concern itself only with such programming from an LCD
Keypad
only.
PROGRAMMING METHODS
LOCALLY (at the panel) REQUIREMENTS
• from any LCD Keypad (covered in this manual)
• the keypad must be DIP switch programmed
and wired to the Pro-24
• power must be applied to the Pro-24
• from a portable computer
• see the Upload/Download Programming Manual
(p/n 5INUD) for additional information
• the PC must be IBM
®
-compatible
• RISCO Group's Upload/Download Software)
must be installed
• the Bus Adapter (p/n RP296EBA) cable and
plug must be connected between a serial
(COM) port on the PC and the Pro-24’s “J1”
connector–or the equivalent connection
* on the 4-wire BUS
• via the Program Transfer Module (p/n RP296EE), a
tiny circuit board into which a copy of a panel’s
programmed configuration is stored–from which it
may later be transferred to any installation when
temporarily plugged into its 4-wire bus
• see page 3-87 for detailed instructions) on the use of
the Program Transfer Module
• the Program Transfer Module (p/n RP296EE)
*
REMOTELY (at the alarm company) REQUIREMENTS
• from a personal computer
• see the Upload/Download Programming Manual
(p/n 5INUD) for additional information)
• the PC must be IBM
®
-compatible
• RISCO Group's Upload/Download Software
must be installed an applicable modem must
be installed and configured access to a
telephone line
*
Table 3-1
*
Not for UL Installations