Installation and Programming Manual 3-21
SYSTEM: SYSTEM LABEL
Quick Key Item Default Explanation
1 5 SYSTEM LABEL --- Creates and Edits System and Partition Labels
1 5 0 Global
RISCO
Allows editing of the global (system) label
1 5 1
through
8
Partitions 1 through 8
PARTITION 1
PARTITION 2
PARTITION 3
PARTITION 4
PARTITION 5
PARTITION 6
PARTITION 7
PARTITION 8
Allows editing of the label used to name each partition
EXAMPLE: To assign the name of “The Jones’s” to
Partition 1, follow these steps:
a) at the display below, press [ENTER]
b) press the [2] key repeatedly until a T appears in
the display; press the DOWN-arrow (BYP) key once to
move the cursor to the right
c) press the [4] key repeatedly until an h appears in the
display; again, press the DOWN-arrow to advance the
cursor
d) press the [4] key repeatedly until an e appears and press
the DOWN-arrow key to advance the cursor
e) press the [6] (or [7], [8], [9], or [0]) key to create a space
and press the DOWN-arrow to advance the cursor
f) press the [1] key until a J appears
use the elements of this procedure to assign other
Partition Labels–each of which may contain up to
12 characters.
1 6
TAMPER SOUND
Sets the Sound(s) Produced by a Tamper Violation of a
Keypad and/or an Expansion Module
1 6 1
through
5
BELL/A
BUZZER/D
(5)
1- Silent
2- Bell (External Sounder) Only
3- Buzzer (Keypad Piezo) Only
4- Bell + Buzzer
5- Bell/A Buzzer/D
if the system was armed
when the Tamper Violation
occurred, the Bell (External Sounder) will operate
if the system was disarmed
when the Tamper Violation
occurred, the keypad will annunciate
SYSTEM: DEFAULT ENABLE/DISABLE
1 7 DEFAULT
ENABLE/ DISABLE
Relates to What Happens if the Main Board’s DEFAULT
(J2) Jumper is in Place When All Power to the Panel is
Reapplied after Being Removed:
1 7 ENABLE if ENABLE is selected: the panel will lose its previously
programmed configuration, including all Labels and
User/Installer Codes. It will return to its original, factory-
defaulted configuration from which it can be
reprogrammed by anyone who knows the default User
and Installer Codes
if DISABLE is selected: the system will be prevented
from being modified by an unauthorized person; thus,
the panel will maintain its previously-programmed
configuration, keeping all Parameters, Labels, and
User/Installer Codes intact. As with any instance of a
total loss of power, it will be necessary to reset the
system’s TIME and DATE
SYSTEM LABELS:
1)PARTITION 1
INSTALLER PROG:
1)SYSTEM
↓
To Next Page
Loading...
