Riso ComColor 7110 - Page 37

35
Preparations for Use >> Paper and Originals
1
Adding Paper in the High Capacity Feeder
To add paper, use the standard tray descent button. The downward
position of the standard tray varies depending on how the standard
tray descent button is pressed. The tray lowers automatically if you
remove all paper from the standard tray.
1
Press the standard tray descent button to lower the
standard tray.
Press and hold the standard tray descent button.
While you are pressing the button, the standard tray lowers.
Press the button until the tray lowers to the position to which
you wish to lower the tray.
Press, not hold, the standard tray descent button.
The standard tray lowers to a certain position.
• The position to which the standard tray lowers
when paper runs out or when you press the
standard tray descent button varies depending
on the “Admin. Settings”. See “High Capacity
Feeder Setting” in the “Administrator’s Guide” for
details.
• When the standard tray is at the bottom, you can
load many sheets at a time, but to do so you need
to crouch down. If you want to load paper
standing up or if you rarely load many sheets at a
time, do not lower the standard tray to the
bottom.
• It is recommended to set the downward position
of the standard tray according to your use. If you
want to change the downward position of the
stacking tray, contact the administrator.
2
Add paper.
If you add many sheets
Press and hold the standard tray descent button to lower the
standard tray to the bottom, and you can load more sheets.
The position to which the standard tray lowers
when paper runs out or when you press, not hold,
the standard tray descent button varies depending
on the “Admin. Settings”. If you want to change the
downward position of the standard tray, contact
the administrator.
Preparing the Stacking Tray
Set up the stacking tray as follows. Depending on the size
or type of paper for printing, also adjust the paper
arranger at this time.
z The auto-control stacking tray is shown in this illustration.
When using the wide stacking tray, manually adjust the
paper guides’ (side and end) positions to t the paper size.
1
Open the stacking tray until it stops.
2
Lift the paper guides (side) to stand them upright.
ComColor Series Basic Guide 06