8. PARAMETER DESCRIPTION
IMR02C15-E4
8-133
Dummy
Function block 60 (F60)
This is the first parameter symbol of Function block 60 (F60).
The settings of parameters in this block require the Communication function
(optional) to be specified.
F60
Communication protocol
Use to select the protocol for Communication function.
Data range Factory set value
0: RKC communication
1: Modbus
Based on model code
For the Communication function, refer to the Communication
Instruction Manual (IMR02C16-E).
Related parameters
Engineering mode:
• Device address (P. 8-133) • Communication speed (P. 8-134)
• Data bit configuration (P. 8-134) • Interval time (P. 8-135)
• Communication response monitor (P. 8-135)
F60
Device address
Device address is used to set the slave address of the controller for
Communication function.
Data range Factory set value
0 to 99 (Modbus: 1 to 99) RKC communication: 0
Modbus: 1
Do not use the same Device address for more than one controller in
multi-drop connection. Each controller must have a unique address
in multi-drop connection.
If the protocol is Modbus, no “0” can be set.
For the Communication function, refer to the Communication
Instruction Manual (IMR02C16-E).
F60.
CMPS
Add
To Next Page
Loading...
Need help?
General
