Rlaarlo CT-8A - Programming Mixing; Joystick Calibration

5.8 Joystick calibration
Enter the joystick calibration setting interface through “System”--> “Joystick”.
confirm to start calibration, push the CH1 direction channel and CH2 throttle channel to the maximum and
minimum, observe the green display box on the display, then return the joystick to the center point and click
calibration to complete.
5.7 Programming mixing
Enter the programming mixing control interface through “MIX Setup”--> “Program”.
Programming mixing control is mainly for the mixing control mode of channel A/B and channel C/D, which can
be applied to the raising and lowering of the winch of model cars.
MIX Setup
Direction
Program
Linearity
ESC Setup
Servos
3 / 5
Programme
Channel A/B
Channel C/D
OFF
OFF
Close
CH: A
CH: B
Close
CH: C
CH: D
System
System
Joystick
Timer
About
Reset
5 / 5
Calibrations
Start
Rudder CH1
Trigger CH2
Toggle to maximum stroke
Release rocker finished
- 8 -