Need help?Do you have a question about the RM Italy BLA 350 and is the answer not in the manual?
General| Frequency | 1.8-30 MHz |
|---|---|
| Input Power | 1 - 10 W |
| Weight | 1.5 Kg |
| Gain | 13 dB |
| Input Impedance | 50 Ohm |
| Output Impedance | 50 Ohm |
| Mode | AM-FM-SSB-CW |
Inspect for shipping damage and check controls function correctly.
Position in a cool, dry area with adequate ventilation for proper operation.
Connect to mains AC network, verify voltage correspondence.
Use with 50Ω antennas; impedance matching may be required.
Connect to the RF ground system of the radio station for safety.
High voltages present; disconnect power before opening the unit.
Use PTT for optimal transmit/receive switching in CW mode.
Tune transceiver/antenna while amplifier is in Standby mode.
Amplifier is inactive; displays status and temperature.
Access and configure amplifier settings like ALC, Temp, VOX, Fan Speed.
Active mode for transmission.
View operational parameters on LCD and meters.
User controls for switching modes and settings.
Protects against over-driving the amplifier with excessive input power.
Monitors and controls heatsink temperature to prevent overheating.
Protects against high Voltage Standing Wave Ratio conditions.
Detects incorrect or faulty band pass filters.
Protects against operation outside specified frequency limits.
To Next Page
