RM Italy BLA-600
Disassembly Procedure
With a TORX (TX10) screwdriver unscrew the right had
side screw underneath the warranty seal.
With a TORX (TX10) screwdriver, unscrew the left hand
screw near the AC input connector.
Pull out the panel to extract the voltage change system
with the corresponding cables.
With pliers, remove all the numbered cables from the
panel. Do not pull the cables to disconnect the
connector.
At this point you should find the panel as in the
picture. Now you are ready to set the AC input voltage
of the amplifier.
To Next Page
Need help?
General
