RoadHog RH4060 - Attaching Unit; Starter Interlock System

8
2.5 ATTACHING TO LOADER
 Read and observe all safety information and
decals on the skid steer loader and attach-
ment BEFORE operating the unit!
 Refer to the SAFETY section of your skid
loaders operator’s manual and observe all
safety recommendations set forth in the man-
ual.
 After attaching planer, inspect engagement of
loader pins before raising unit
 Always lower the loader arms fully before
leaving the skid steer seat.
FAILURE TO FOLLOW THE PROCE-
DURES BEFORE OPERATING OR
SERVICING THIS UNIT COULD LEAD
TO SERIOUS INJURY OR DEATH.
WARNING
2.6 STARTER INTERLOCK SYSTEM
 This RoadHog does not have a clutch,
therefore the drum turns when the engine
is cranking or running.
 This RoadHog is equipped with a starter in-
terlock system. The system is designed to
prevent the engine from starting if the unit is
not attached to a loader and / or not lifted off
of the ground.
 Never wire or “jump” around, or disable this
system.
 Inspect system periodically to ensure the
ski within this system is free to move up
and down. See photo below of this im-
portant feature.
 The starter interlock skid pivot has a grease
zerk. This zerk is located on the starter inter-
lock ski, located on the left rear of the
RoadHog, below the fuel tank. This zerk
should be greased once a week or every 40
hours of operation.
FAILURE TO FOLLOW THE PROCE-
DURES BEFORE OPERATING OR
SERVICING THIS UNIT COULD LEAD
TO SERIOUS INJURY OR DEATH.
WARNING