continued from preceding page
away from pre-existing components, close to the center.
Note: attach the connector close to the center. If the
harness is attached too far to either side, it may be pulled
away when the motorhome turns.
14. Attach the connector with one of the included wire ties.
Allow enough slack so that it can be easily connected and
disconnected from the matching male connector on the six-
foot power cord.
15. With a test light, identify the wires conducting the brake,
turn signal, taillight and ground signals from the motorhome.
Use butt connectors (not supplied) to connect the appropriate
wires to the section of electrical harness.
Use a second ring terminal (not supplied) to ground the
motorhome, preferably directly to the frame.
16. Connect the power cord to the motorhome and towed
vehicle. Test to make certain that the towed vehicle's turn
signals, taillights and brake lights operate in conjunction with
those of the motorhome.
To Previous Page
Loading...
