continued from preceding page
6. Attach one end of the remaining length of red 12 gauge
wire to the gold post on the circuit breaker (identified as ‘BAT’)
in the identical manner.
Route this wire to the positive post and cut to length.
If helpful, you may use the included 5/16” ring terminal to
attach it. The vehicle’s engine must be off when you attach the
wire to the post.
7. Ensure that a good ground exists between the frame of
the towing vehicle and the frame of the towed vehicle.
Note: to confirm that the charge line is functioning…
• With the motorhome engine running, connect a volt
meter or test light from the number 4 pin in the motorhome
socket to the motorhome ground.
• If the volt meter or test light indicates 12 VDC
+
, the
charge line is functioning.
To Previous Page
Loading...
