6
Access Keypad Installation Guide
5 Press #.
6 Enter a new passcode (3 to 6 digits).
7 Press
#.
8 Note the new Master Pass Code and store in a safe place.
To restore a factory default code, follow these steps:
1 Make sure the keypad has power.
2 Enter the Master Pass Code.
3 Press
#.
4 Enter the slot number (1 or 3 for Bypass, 2 or 4 for Reset).
5 Press
#.
6 Do NOT enter a passcode.
7 Press
# again.
8 The default passcode is restored.
Master Reset
To reset the keypad to its factory default passcodes, follow these steps:
1 Apply power to the keypad.
2 Short the contacts on the J7 solder points at the upper right of the keypad
back. (See Figure 1 on page 7.) The keypad will beep.
3 Press the * key three times. The keypad will beep to indicate that the defaults
are loaded.
To Next Page
