A818
1
Contents indicated by are warnings. Failure to follow the instructions will cause danger.
Figure 1
Decorative panel
Switch
CXW -2 00- 83 02
Thank you very much for choosing ROBAM range hood.Please read the manual carefully before using the product.
Introduction
Important
Dear user
Technical Specification
吸油烟机
Range Hood
Packaging of New Hood
Please dispose the packaging materials in an environmentally-friendly way to maintain a good environment.
Keep children away from the plastic film and packing carton. They are not toys and may cause choking.
Disposal of Old Hood
If the old hood cannot be used any longer, it is recommended to dispose it to an “unusable” state before discarding.
Please assist disposing or recycling the useable materials from the old hood, thus contributing to the environmental
protection.
Before Using the New Hood
The range hood exhausts fumes outside.
Before installing and using the product, please carefully read and strictly follow the instructions and accompanying
documents. When necessary, also read the Operation Manual of your gas hob and save them properly for future
reference.
As the manual apply to different types of hoods, you may find some extra characteristics described here.
If obvious damage is found, do not energize it and immediately contact your local dealer or the service center.
Don't let unsupervised children and frail people use the hood alone. Otherwise, it will cause electric shock or other
injuries.
≥280Pa
18m/min
3
Rated input power of the
main motor
≥23%
≤4W
Dimensions (L×W×H)
Maximum static pressure
Odor decrease rate ( normal)
Odor decr ease rate (inst ant aneous )
≥80%
≥350Pa
≥98%
Rated input power of the hood
204W
200W
Grease separation rate
≥96%
Noise
Maximum input power of
the light
Net weight of the host
Model
Power supply
Full pressure efficiency
Nominal pressure
Air flow rate
CXW-200-A809
CXW-200-A818
220-240V~ 50Hz
≤57.5dB
A809：895×524×597(mm)
A818：895×504×652(mm)
A818：26kg
A809：25.5kg
1. The deviation between the specified value and actual value of airflow shall not exceed 10% of the
specified value.
2. When stir- frying function is enabled, the power will increase by 5% compared to strong power (level-3)
3
and the airflow is 19 m /min.
To Next Page
Loading...
