Roberts Blutune 200 - Scan Sensitivity Setting - FM

21
Scan sensitivity setting - FM
Your sound system will normally scan for FM broadcasts which are strong
enough to give good reception. However, you may wish the Auto-scan
function to also be able to fi nd weaker signals, possibly from more distant
radio transmitters. Your radio includes a local / distant option for the Auto-
scan function.
1. Press and release the On / Standby button to switch on your sound
system.
2. If needed, press and release the Mode button until the FM band is
selected.
3. Press and hold the Menu button. 'FM Menu' will appear on the display.
Press and release the Select button to enter the FM menu.
4. Press the Tuning Up or Down buttons until 'Scan setting' shows on
the display. Press and release the Select button to enter the scan
sensitivity adjustment mode.
5. Press the Tuning Up or Down buttons to switch between Local ('Strong
stations only') and Distant ('All stations') options on the lower line of the
display. The Distant option will allow the radio to fi nd weaker signals
when scanning.
6. Press and release the Select button to confi rm your selection. The
Local or Distant setting is stored in the radio and remains in force until
changed or until a System Reset.
Note: The initial setting (out of the box, or after a System Reset) causes
the radio to ignore weaker (or more distant) signals.
3
4,5
4,5
3-6
2
FM Menu
<
>
FM
Scan setting
<
>
Scan setting
Strong station
<
>
*
Scan setting
All stations
<
>
*