21
Specifications
Power Requirements
Mains AC 230 volts, 50Hz only
Frequency Coverage
FM 87.5-108MHz
MW 522- 1629kHz
LW 153- 279kHz
Loudspeaker 75mm x 100mm 4ohms
Output Power 800 mW
Headphone socket 3.5mm dia
Aerial System FM Wire aerial
MW Built-in Ferrite aerial
LW Built-in Ferrite aerial
Troubleshooting
1. If the time does not set automatically it may be necessary to rotate
your clock radio to a position giving better reception of the MSF
signal.
2. It is recommended that your clock radio is placed as far away as
possible from any sources of interference such as computers or
televisions, etc.
3. To re-synchronise with the MSF time signal, press and hold down the
time button until your clock radio beeps. The MSF indicator
will flash whilst synchronisation takes place. Synchronisation is
complete when the MSF indicator stops flashing.
At certain times of the year the MSF transmitter closes down for
maintenance. During this time the clock will not automatically set
(see the section headed Manual setting of the clock displays).
Recorded information on MSF transmitter status can be obtained on
020 8943 6493.
3
To Next Page
Loading...
