Roberts iDREAM 2 - Return to Auto Clock Set Mode

27
To return to auto clock set mode
1. Press the On / Standby button to switch on the clock radio.
2. Press and release the Menu button to enter the setup menu.
3. Press the Tuning Up or Down button until 'CLOCK' appears on the
display. Press and release the Select button.
4. Press the Tuning Up or Down button until 'AUTO CLK' appears on
the display. Press and release the Select button.
5. The radio will set its time according to the information received with
the DAB broadcast when the radio is tuned to a DAB station.
Note: If you select 'AUTO CLK' the current time received will be displayed.
If no DAB signal is found, 'NO CLOCK' will be displayed. You should then
either position the radio or its aerial so that a signal can be received, or
revert to manual clock mode (see page 25).
3,4
3,4
3,4
2