31
Stereo / Mono setting - FM
Your radio will play stereo FM broadcasts in stereo provided that the
received signal is of adequate strength. However, as a stereo signal
becomes weaker the audio signal will become poorer. It may be preferable
to force the radio to play the station in mono in order to reduce the level
of backgound hiss.
1. Press the On / Standby button to switch on your clock radio.
2. Tune to the required FM radio station as previously described (see
pages 12, 13).
3. Press and hold the Select button until the display shows 'MONO'.
While this setting is engaged, the radio will play the current station in
mono.
The Mono override is a temporary setting and is applied to the currently
tuned station only. It is cancelled automatically by tuning to another
radio station.
4. If you wish to cancel the Mono override while listening to the currently
tuned radio station, press and hold the Select button until the display
shows 'AUTO'. The radio will then play the current station in stereo if
the signal is suffi ciently strong.
3,4
1
To Next Page
Loading...
