If you need any further advice, please call our Technical Helpline on :-
0181 758 0338 (Mon-Fri)
37
3. Press and hold down both the tuning [ ] and [ ]
buttons for more than 2 seconds. The radio will beep
and the display will flash indicating that the ra-
dio is in APS mode.
4. The radio will scan from the lowest frequency on the
selected band, automatically storing stations in preset
memory based on signal strength order.
5. After APS is complete the display will show 1
and the station with the strongest signal for your area
will be selected.
Note:
a. During APS only the 9 strongest stations on MW and
18 strongest stations on FM will be stored.
b. All previously stored stations will be erased when APS
operation commences.
c. APS operation can be cancelled by pressing the
"Power" button
To Next Page
