Roberts Stream 104 - Configuration; Plugging In and Language Selection

9
Confi guration
Plugging in and language selection
1. Place your radio on a fl at surface and plug the cable from the mains
adaptor into the DC input socket located at the left hand side of your
radio (marked 'DC') ensuring that the plug is pushed fully into the
socket.
2. Plug the mains adaptor into a wall socket and switch on the socket.
IMPORTANT: The mains adaptor is used as the means of connecting
the radio to the mains supply. The mains socket used for the radio
must remain accessible during normal use. In order to disconnect the
radio from the mains, the mains adaptor should be removed from the
mains socket outlet completely.
3. When you apply power, the display on the radio will light up and say:
'ROBERTS' and 'STARTING' with a progress indicator. After a few
seconds the radio will then enter Standby and the clock will display
'00:00' as shown.
To continue to set up your radio press and release the On/Standby
button. If this is the fi rst time that you use your radio (or a Factory
Reset has been carried out) the display will show 'Setup wizard' and
'YES' will be highlighted on the screen.
4. By default your radio will display all menus and messages in English.
If English is your preferred language then press the Tuning/Select
control to select 'YES' and to begin setting up your radio.
If you selected 'YES', please skip to step 1 on page 11.
5. If your preferred language is not English, then rotate the
Tuning/Select control so that the 'NO' option is highlighted.
Press the Tuning/Select control to enter the selection.
Continue on the next page.
9'&,1


4,5
3