75
Brightness
Language
Factory Reset
Software update
Setup wizard
2-7
4,7
Brightness control
The brightness of the display can be adjusted for when the radio is in standby and for
when it is in use. If you use the unit in the bedroom, you may prefer a lower standby
brightness level than the standard setting. There are three Standby brightness levels
and 3 levels for when the radio is in use.
To change the current brightness setting please follow these steps.
1. Press and hold the Info button to access the display brightness setting.
2. Rotate the Tuning/Select control to choose either the High, Medium or Low
brightness level. Press the control to set the level.
3. If the sound system is playing, then the chosen brightness will be applied
immediately. If the sound system is in standby, then the chosen brightness will
be applied after a 10 second delay.
4. Alternatively you can set the display brightness using the menu system. Access
the menu for the current mode by pressing the Menu button.
5. Rotate the Tuning/Select control until 'System settings' is highlighted on the
display. Press the control to enter the System Settings menu.
Rotate the Tuning/Select control until 'Brightness' is highlighted on the display.
Press the control.
6. To adjust the display brightness when the sound system is switched on rotate the
Tuning/Select control until 'Normal' is highlighted on the display.
To adjust the display brightness when the radio is in standby rotate the Tuning/
Select control until 'Standby' is highlighted.
Press the control to enter the selected brightness adjustment mode. The current
setting will be marked with an asterisk.
7. Rotate the Tuning/Select control to choose either the High, Medium or Low
brightness level. Press the control to set the level. Press the Menu button to exit.
When the sound system is in Standby mode, pressing a button or turning a rotary
control will cause the sound system to switch to the normal brightness level for a
few seconds. This is so that even if the standby brightness level is set low, it is still
possible to see the time when needed.
1
High
Medium
Low
Brightness
*
Normal
Standby
Brightness
High
Medium
Low
Brightness
*
To Next Page
Loading...
