Page 5 of 8
Rev 02 01/11/13
LAP/SPLIT Chronograph Operation
Please note that “LAP/SPL” is commonly referred to as “dual split” timing.
While in the Chrono (CHR) mode, press “D” until “LAP/SPL” indicator appears.
Single Events: Press “A” to start. Press “A” again to stop. Press “B” to reset to all zeros.
Timing Multiple Dual Splits: Press “A” to start. “RUN” indicator appears. Time is shown running in both
the upper and lower rows of the display. LAP COUNTER will show “001” indicating this is the first
segment.
Press “B” to take a Dual Split time reading. The time reading will appear frozen in the upper and lower
rows of the display. The SC-606W will automatically release the frozen display to the current running
LAP and SPLIT times after 15 seconds.
Upon releasing the frozen time display, the LAP COUNTER will increase by one (1) to indicate the second
segment is now displayed.
The SC-606W will take up to 999 Dual Split readings. You may recall up to the previous 50 at any time by
pressing “D”.
To stop the Chrono, press “A”, then, press “B” to reset to all zeros.
NOTES:
After 24 hours or 999 laps, the chronograph will cease operation.
The time value in the upper row will have 1/100 second resolution for the first 60 minutes. After 60
minutes, it will have one (1) second resolution up to 24 hours. The time value in the lower row will
have 1/100 second resolution for up to 24 hours.
If no pushbutton is pressed for 15 seconds, the SC-606 will return to the last previous time value if
MEMORY RECALL and AVG/MAX functions are activated.
PART V COUNTDOWN TIMER OPERATION
The SC-606W offers a Multi-Mode Countdown Timer (CDT) which displays the time remaining in an
event. For example, the game clock at a football or basketball game is a Countdown Timer.
The reset time and mode is set and appears in the upper row of the display, while the actual time remaining
appears in the lower row.
The Countdown Timer has three (3) modes from which to choose:
(1) Countdown STOP (CdS) Timer automatically stops upon the completion of the countdown time.
(2) Countdown REPEAT (Cdr) Timer automatically repeats upon the completion of the countdown time.
(1) Countdown Count-up (CdC) Acts as a “Count Up” chronograph with 1/10 second resolution upon
completion of the countdown time.
You may preset times from 1 second up to 24 hours. The time remaining will be displayed within 1/10
second resolution.
SETTING THE COUNTDOWN TIMER
From NORMAL TIME, press “C” twice to enter the Countdown Timer mode. If the “RUN” indicator
appears, press “A” to stop and “B” to reset the timer.
To Next Page
Loading...
