-
39
-
Air gap : 0.3 - 0.5 mm
(0.012 - 0.020 in.)
Fig. 5-37a
5-4-12 IGNITION COIL
Install ignition coil to crankcase.
Pay attention the direction of ignition coil and the
location of code.
Adjust air gap between ignition coil and flywheel
using a thickness gauge and tighten bolts.
M6 x 25 mm bolt and washer : 2 pcs.
Fig. 5-37b
Model: EH09D
Model: EH12-2D
5-4-13 INTAKE PIPE, INSULATOR (EH12-2D)
(1) Install the intake pipe to the cylinder head with
gasket.
M6 flange nut : 2pcs.
M6 x 40 mm bolt and washer : 1pce.
Then put the gasket and insulator on the intake
pipe.
Tightening torque : 9.8 - 13.7 N・m
(100 - 140 kg・cm)
(7.2 - 10.1 ft・lb.)
THICKNESS
GAUGE
IGNITION COIL
THICKNESS GAUGE
IGNITION
COIL
euqrotgninethgiT
N8.01-8.8 ・m
gk011-09( ・ )mc
tf0.8-5.6( ・ ).bl
Fig. 5-38
M6 x 40 BOLT
AND WASHER AY: 1 pce.
M6 NUT : 2 pcs.
GASKET
INTAKE
PIPE
To Next Page
Loading...
