Robin EH09D - STARTING SYSTEM; Recoil Starter

- 62 -
Fig. 9-1
9-1-1 Disassembly Steps
(1) Setting off the spring power
-1 : Hold the starter knob and extract the starter
rope.
-2 : Extract the rope fully and hold the rope so
that the knob of the rope in the reel makes
a direct line with the rope guide.
-3 : Push and hold the reel with the thumbs of
both hands firmly so that the rope will not
be wound back. (Fig. 9-1)
-4 : Pull off the knot of the rope out of the reel,
unfasten the knot and pull it off to the di-
rection of the starter knob. (2 persons re-
quired)
-5 : By controlling the reel with the thumbs of
both hands, unwind the rope gently until
the rotation of the reel Stops.
9. STARTING SYSTEM
9-1 RECOIL STARTER
Tools required: Driver, Pinchers (Pliers) and Protective Glasses
WARNING :
The spring power is at its most when the rope is fully extracted. Therefore, do not abruptly
put off your hand nor loosen the pressure of your finger unintentionally.
WARNING :
Before starting the disassembly, make sure to wear the protective glasses.