Robin EH09D - Assembly Steps

- 63 -
Fig. 9-2
SET SCREW
RATCHET
GUIDE
FRICTION
SPRING
RATCHET
REEL
STARTER
CASE
(2) Setting the attachments off (Fig. 9-2)
-1 : Fix the case and loosen the set-screw.
-2 : Put off the set-screw, the ratchet guide,
the friction spring and the ratchet in the
same order from above.
(3) Setting the reel off (Fig. 9-2)
-1 : Push the reel lightly so that it will not float
up. Move the reel clockwise and counter-
clockwise about a quarter circle for sev-
eral times until it moves smoothly.
-2 : Pull up the reel gradually and slowly and
put it off from the case.
-3 : In case the spring in the reel is close to
pop up, redo the steps of (3)-1 and (3)-2
again.
WARNING :
Do not drop or shake the reel and put it
on a level table because there is a spring
set in the disassembled reel.
Disassembly is complete.
WARNING :
Before starting the assembly, make sure to wear the protective glasses.
Fig. 9-4
GREASE PASTING
SHAFT / HOOK PARTS
THE POSITION THE END TOUCHES
THE RIB OF THE BEARING
Fig. 9-3
9-1-2 Assembly Steps
(1) Setting the reel into the case.
-1 : Paste grease on the case. (Fig. 9-3)
-2 : Adjust the position of the inner end of the
spring, which is set in the reel. (Fig. 9-4)
-3 : Hold the reel so that the shaft/hook part
and the inner-end of the spring are hooked
together. Drop the reel gently from above
into the case.
-4 : Move the reel slightly counterclockwise and
make sure the spring is hooked.