-
64
-
(2) Setting the attachments
-1: Set the ratchet into the reel. (Fig. 9-5)
Fig. 9-5
THE RATCHET IS KEPT AT CLOSE-POSITION
-2: Holding the ratchet, set the ratchet-guide
subassembly. (Fig. 9-6)
Fig. 9-6
SET SCREW
RATCHET
GUIDE
FRICTION
SPRING
RATCHET GUIDE SUB-ASSEMBLY
(3) Tightening the set-screw.
-1 : Push the ratchet-guide lightly by hand so
that the ratchet guide won't move and
tighten the set-screw.
(4) Storing the spring-power.
-1 : Hold the case tight and using both hands,
wind up the reel counterclockwise 6 times.
-2 : Set the reel to keep the position, whereby
the rope hole of the reel and the rope guide
make a direct line. (Fig. 9-7)
Fig. 9-7
ABOUT 200mm
FROM THE REEL
WARNING :
The spring power is at its most when the reel is being wound. Therefore, do not abruptly
put off your hand nor loosen the pressure of Your finger unintentionally.
To Next Page
Loading...
