6.
Refer to Figure
7-9.
Wind rope
2Y2
turns clock-
:
wise in reel and press rope in notch. Install reel
over support shaft. Align the reel hook
to
the
inner end of the spring and install the reel in the
starter case.
Figure
7-9.
7.
With rope pressed into notch, hold reel securely
in housing and turn reel counterclockwise
4
revolutions. Remove rope from notch. Let reel
slowly
turn clockwise as rope winds onto reel
and handle returns to guide bushing.
8.
Refer to Figures
7-2
and
7-3.
Install all parts
as shown.
:
Refer to Figure
7-10.
For
Model
WO1-210
bend
the return spring up and install the friction spring
cover as shown.
Next,
turn the friction spring
cover clockwise till the notch. aligns with the
ratchet. Install thrust washer and snap ring.
9.
Test starter for satisfactory operation before
mounting
on
engine
Figure
7-1
0.
7-3
To Next Page
Loading...
